How to graft loquat trees

Article Catalog

1. Grafting method

2. Precautions

---

When grafting a loquat tree, the branches should be one meter high and can be cut off at 15-20cm. It should be noted that the cut should be at a slight angle. After preparing the branches, make a small, sloping cut on the smoother trunk. The cut should not be too deep. Insert the scion into the cutout on the tree you just prepared, and then use a certain tool to wrap the joint.

1. Grafting method

1. Grafting method

1. Saw anvil: The position of the grafted branch should be one meter high. Choose a tree with only 2-3 branches. Which branch is going to be used? Use a saw to cut off -20cm, and other thinner branches can be cut off. The wound should be made relatively flat, and the incision should be slightly inclined.

2. Cutting stock: The skin of the tree is relatively smooth Use a knife to cut a small opening with an inclination. The cut should not be too deep, just where the bark and the wood inside are in contact.

3. Cut the scion: Use a knife to cut an inclination angle of 45o on the bottom of the selected scion. The bevel should be 1.5cm long, leaving two small holes on the other side of the scion. The part can be cut off.

4. Bandaging: Connect the scion to the interface, and then tie it tightly with the prepared tools. This will not only make it extremely strong, but also speed up the recovery of the wound and make the grafting successful. rate increases.

2. Precautions

1 , scissors and saws are relatively sharp, so be careful not to injure yourself when operating them.

2. The wounds cut with scissors and those cut with saws should be made relatively flat, not irregular, and the cuts must be somewhat inclined.

2. Precautions

- END -