She used these "wrong ways" to grow flowers, and the flowers exploded and flooded the pots

Article Catalog

---

Using the most conventional methods, only the most common flowers can be grown. If you want to grow flowers that look good and look stunning, you have to avoid taking the usual path. Today Huahua will teach you some "wrong ways"~

Cramming fertilization

Many gardeners say that fertilizing is too smelly, thankless and attracts insects, which is really tiring to think about. Today Huahua will introduce to you a time-saving and labor-saving method. The most important thing is to be very clean~

① Prepare a plastic bottle, it doesn’t need to be too big, just a mineral water bottle you usually drink, cut off the bottom of the bottle .

② Bury the plastic bottle into the flower pot and cover it with soil Only the bottle cap is exposed. Note that when burying, the bottle should be on the edge of the flower pot and not too close to the middle. Otherwise, it will not only block the growth of the root system, but also easily burn the roots during the retting process.

③ Open the lid of the plastic bottle and remove the watermelon rind and vegetables. The leaves, peel, etc. are cut into pieces, filled into plastic bottles, and then the bottle caps are tightened for fermentation.

< p>④ In the future, as long as there are leftovers at home, you can fill them into plastic bottles. After 2-3 months, the peels and vegetable leaves that were first filled into the bottom of the pot have rotted, and you can replenish nutrients for the flowers.

⑥ The advantage of retting in this way is that it will not burn the roots, because The fermentation process is all carried out in plastic bottles, the heat generated will not burn the roots, and the lid of the bottle will not produce odor or attract insects. If you are still worried about bugs, you can add some insecticides such as carbofuran during the process of filling the peel and rotten leaves.

One-knife pot explosion

At home I have been raising cactus for several years, but it still looks the same as when I bought it, lifeless. It may be that it is too comfortable and does not want to make progress.

You must give it a knife and let it feel yours anger. In fact, it breaks its internal balance and stability. When it feels that danger is approaching, it will grow wildly.

① Prepare a sharp knife and disinfect it with carbendazim solution.

② Find about 1/3-1/2 of the cactus position, cut off the upper part sideways.

③ Apply a little more on each of the two cut parts. Bacteria should be placed in a ventilated and astigmatized environment for 1-2 days to allow the cut surface to dry.

④ Do not use any remaining cactus in the pot within 2 weeks Get wet. After normal maintenance, it will give birth to many cubs one month later!

⑤ And cut down Part of it, after it is dried and placed in new soil, will also take root again, and you can have another pot of cactus.

One-pull bud growth

If your rose is thin, tall, and teetering on the edge of collapse, you can pull it until it doubts life. In this way, it can work hard and sprout like bamboo shoots within a week. In the future, your rose can be transformed from one plant into a pot.

▽ Pull the front

▽ After dragging

? Method 1: Pull the main branch horizontally

① Separate the branches on both sides of the rose and press them at 90 degrees to both sides.

② Fix the branches with ropes or wires to keep them stable It doesn’t rebound, so be careful not to pull it too hard and break it.

③ In this way, the original branches of the rose will lose their top edge. Within 1 week, new shoots will emerge from the base. Try it with any trial.

④ If the buds sprout too much and too densely, you can Pick off a few weaker ones appropriately to leave nutrients for the stronger branches to grow.

? Method 2: Side basin

① Tilt the rose pot at 45°, so that the side with fewer branches and weak branches faces upward.

② In this way, the weak side of the branch will form a top advantage , more new buds will sprout, the rose will grow more branches, the plant will be plumper, and there will be more flowers.

? Method 3: Break branches

① Select some weaker branches and fold them near the lower part.

② Be careful not to break it completely, just break it in half, and Make sure that there are still 2-3 bud points in the lower part of the broken part, so that more branches can be sprouted, otherwise the break will be in vain!

③ About 1 week later, the lower part of the broken branch New shoots will sprout!

Are these "crooked ways" magical?

Learn quickly,

Maybe you will need it in the future~

- END -