How to propagate single-leaf green radish

Article Catalog

1. Water insertion

2. Soil insertion

3. Leaf cuttings

---

Choose a container for water insertion, cut off strong stems with more than 3 sections in each section, and insert the base into clear water. For soil transplantation, you need to cut branches about 15cm long, insert the branches into a breathable matrix, and place them in a semi-shady place to ensure a temperature range of 25°C. Keep the periphery of the leaf cuttings above 20°C. Select the strong leaves in the upper part, wash them and dry them in the sun. When the cuts are slightly dry, insert them into clean water.

1. Water insertion

1. Water insertion

1. There are no requirements for the container. As long as it is transparent and the changes in the root system can be observed, the mouth of the bottle should not be too large to prevent the water from evaporating too quickly.

2. Cut off plants that are growing well and select strong stems with more than 3 nodes in each section. It doesn’t matter even if only a single leaf is left, as it can reduce water evaporation.

3. Insert the base into clean water. Change the water more frequently at the beginning. Later, you can change it 1-2 times a week. Wait about half a month for new roots to sprout. Then continue hydroponics or It can be planted into the soil.

2. Soil inserts

1 In the three seasons of , spring, summer and autumn, cut branches about 15cm long to ensure that there are no diseases and insect pests.

2. The most important thing for the culture medium is to ensure ventilation and drainage. Insert the branches into it, and insert 3-5 branches into each flower pot.

3. After inserting, place it in a semi-shady place to ensure a temperature range of 25°C. Roots will take place in about three weeks.

3. Leaf cuttings

1 , The temperature should be kept above 20℃. This temperature is suitable for growth and is very helpful for later development.

2. In order to increase the chance of survival, it is best to choose the upper part of the strong leaves, cut them off from the petiole with a sharp thin blade, then wash them in clean water and leave them in a cool place for a few days. Hour.

3. When the incision is slightly dry, remove the base of the leaf Insert it into clean water to a depth of about 1.5cm. If the water level is too low and the water level is not replenished in time, the leaves will shrink. If inserted too deep, the petiole will rot.

2. Soil insertion

3. Leaf cuttings

- END -