How to cut dendrobium strips at home

Last Update :2024.12.20

Article Catalog

1. Cutting time

2. Cut the cuttings

3. Cutting processing

4. Matrix selection

5. Make cuttings


The cutting time can be selected from March to October. The mother plant from which the cuttings are taken must be of good quality. Choose 1-2 year old branches with a length of 3-5 cm. Cut them and soak them in a disinfectant solution for disinfection. The cutting substrate needs to be breathable, drainable, and soft. Insert the cuttings dipped in rooting powder with the bud eyes facing upward. Keep moisture after cutting, and pay attention to spraying water to moisturize.


How to Cut Dendrobium Strips at Home
1. Cutting time

1. Cutting time

There are not many restrictions on the cutting time. You can choose from March to October. Winter is not suitable because the temperature is low and it is difficult to take root.

Dendrobium

2. Cuttings

The mother plant from which the cuttings are taken must be of good quality, in a strong state, and guaranteed to be free of diseases and insect pests. Select 1-2 year old branches from the top, and make the lower incision about 0.2-0.5 cm below the petiole. Cut it on a cloudy day or in the morning. , the length should be kept at 3-5 cm, and the water in the scion should be full and substantial, so that the wound will heal easily after cutting and the survival rate will be relatively high.

3. Treatment of cuttings

After cutting, soak them in disinfectant solution for about 10-15 minutes. After taking them out, rinse them with clean water, and then dip them in rooting powder.

4. Substrate selection

The cutting substrate needs to be breathable, drainable, and soft. It can be prepared with sawdust and organic soil. Before use, it should be exposed to strong light to ensure that it can remove pests and diseases. , to avoid trouble later.

Dendrobium

5. Make cuttings

Insert the cuttings dipped in rooting powder, with the bud eyes facing up, and insert them at a slight angle. It does not need to be too deep, just keep it at almost half of the cuttings. It is necessary to maintain moisture after cutting, and pay attention to spraying water to moisturize, and not too dry.

Dendrobium

2. Cut the cuttings

3. Cutting processing

4. Matrix selection

5. Make cuttings










- END -

Can asparagus spend the winter outdoors?

Whether asparagus can survive the winter outdoors depends on the local climate con...

Can Alocasia be kept in the bedroom?

Alocasia is a plant that is often seen in daily life, but it is toxic. It can be k...