Charizard cutting method

Article Catalog

1. Time selection

2. Cut the stem segments

3. Preparation matrix

4. Carry out cuttings

---

The cutting time of Charizard can be selected in spring, summer and autumn. Choose a fire-breathing dragon plant that is in relatively good growth condition, cut off a stem segment and keep it at a moderate length, about 10cm. The substrate is mainly breathable. You can use vermiculite or perlite, with a thickness of about 5-10cm. Insert the dried stem segments into the substrate. Pay attention to spraying water to keep it moist, which can promote rooting.

1. Time selection

1. Time selection

There are not many restrictions on time selection. You can choose to do it in any of the three seasons: spring, summer, and autumn. Spring germination is strong and can promote growth. The higher humidity in the air in summer and autumn can promote germination and rooting. Winter is too cold to be suitable.

2. Cut the stem segments

Choose a fire-breathing dragon plant with a relatively good growth status, and cut a stem segment from the top. It needs to be fuller and free from pests and diseases. Healthy stem segments are conducive to survival. The length does not need to be too long, about 10cm. Do not insert it immediately after cutting it, because there will be white juice flowing out from the bottom. You can wash it off in water, or you can put it in a cool place to dry and wait for the wound to heal.

3. Preparation matrix

Selection The substrate is mainly breathable. You can use vermiculite or perlite. Both of these are acceptable. The thickness of the laying is about 5-10cm. Before use, disinfect the container and substrate and pour a certain amount of water. Keep it hydrated.

4. Make cuttings

Insert the processed stem segments into the substrate to ensure that they do not tip over. Be careful to spray water on them to promote rooting as soon as possible.

2. Cut the stem segments

3. Preparation matrix

4. Carry out cuttings

- END -