Homemade creeping flower stand

Article Catalog

1. Production method

2. Precautions

---

It is not difficult to make a homemade climbing flower stand. You can bend two iron wires and cross them, insert them into the flower pot, use a rope to tie the wire joints, and then wrap a thin wire around the outside. Or you can find a few pipes and insert them into the soil, and just use wires to hang them on the outside. You can also use Dutch netting to make it according to the size of your own flowerpot, as long as the diameter is the same.

1. Production method

1. Production method

1. Prepare two wires and bend them from the middle. Bend two wires and insert them into the flower pot using a criss-cross method. Where the two wires are joined, use a tool to bind it, otherwise it will easily fall apart. Then prepare a slightly thinner wire and wrap it around the outside of the flower stand, which will make it easier for plants to climb.

2. Find a few clean pipes, and then When inserting them into the flowerpot, be sure to insert them all the way, otherwise they will shake easily. Then use thinner wire to wrap around the outside of these pipes, and then use wool to tie it up.

3. It is also possible to make a pergola using common Dutch netting, and the production method is also very simple. Surround the Dutch net together according to the diameter of your flower pot. The diameter of the flower stand should be the same as the diameter of the flower pot. Finally, use a tool to tie it up and insert it into the flower pot.

2. Precautions

In When making a flower stand, you must pay attention to its firmness. If it is too loose or tilted, it will be harmful to the climbing plants.

2. Precautions

- END -