Grafting process of rosewood

Article Catalog

1. Time selection

2. Grafting method

---

A suitable time should be chosen before grafting, and it is best to do it in the morning or evening in autumn. When grafting, strong rose branches should be cut off, and the top leaves should be retained. The side branches and leaves of agarwood should be cut off, and the main trunk should be retained. Soak the branches in the nutrient solution, cut a hole at the top of the agarwood, insert the branches and tie them up. Do not expose it to water until it has healed.

1. Time selection

1. Time selection

Before grafting, you should first understand the appropriate grafting time and try to choose a relatively warm time. Therefore, it is recommended that you graft in autumn. Moreover, the climate during grafting should not be too humid. It should be carried out in a dry environment. Grafting can be done in the morning or evening, so that the wound can heal in a shorter time.

2. Grafting method

1 . Processing work: When grafting, relatively strong branches should be selected from the rose plants. The top leaves should be appropriately retained, and the lower leaves need to be cut off. Then there is the processing of woody wood. Its main trunk should be retained, and some leaves and side branches need to be cut off.

2. Grafting: Put the cut branches into the nutrient solution, take them out for about 3.4 hours, and then place them in a ventilated and cool place. Cut a 5-10cm wound on the top of the main stem of the woodland tree, insert the rose branches into it, and tie it with plastic film.

3. Later management: every week after grafting Check it. If there is no healing, it should be grafted again. It can usually be seen within one month whether it has survived. When the wound has not healed, it needs to be protected from rain and do not fertilize it.

2. Grafting method

- END -