How to take cuttings of Heartleaf Vine

Article Catalog

1. Cutting time

2. Cut the stem nodes

3. Preparation matrix

4. Carry out cuttings

---

The cutting time of Heartleaf Vine can be selected from May to September, and the survival rate is relatively high. Choose vigorously growing plants, cut off strong stem nodes, keep 2-3 nodes, and remove the lower leaves. Do not cut the cuttings immediately after cutting them, put them aside to dry first. The substrate can be coarse sand or sphagnum moss. Dip the cut stem segments into rooting powder and insert them into the substrate. If you do a good job of post-care, it will take about 20-25 days to take root.

1. Cutting time

1. Cutting time

Choosing the right time for cutting is very important. The best time for cutting is from May to September. The climate during this period is relatively suitable and is very suitable for cutting. , the survival rate is relatively high. Cuttings can also be taken in other seasons, but the survival rate is not as high as that time.

2. Cut the stem nodes

Choose vigorously growing plants, which require good growth. Cut strong stem nodes from the top. They require good growth and no influence from diseases and insect pests. 2-3 nodes should be retained on the top. One leaf can be retained at the top, and the lower leaves need to be removed. , the leaves cannot be retained too much, otherwise the evaporation will be strong, which will not be conducive to rooting and survival in the later period. After cutting it, you cannot cut it immediately. You can put it aside to dry first so that the bottom is slightly dry.

3. Preparation of matrix

Matrix The choice of soil is also very important. You can use coarse sand or sphagnum moss to keep the substrate moist and promote rooting in the later stage.

4. Make cuttings

These After preparation, you need to make cuttings. Dip the cut stem nodes into rooting powder, and then insert them into the substrate. Do a good job in later maintenance and keep the temperature at 22-24 degrees Celsius. The cuttings will take root in about 20-25 days.

2. Cut the stem nodes

3. Preparation matrix

4. Carry out cuttings

- END -