The correct method and time for cutting tiger piranha

Article Catalog

1. Cutting method

2. Cutting time

---

To make tiger orchid cuttings, you need to select suitable leaves. Cut full, fresh, disease-free and pest-free leaves from the strong mother plant, divide them into sections, and place them aside to dry while the cuts are made. Prepare suitable soil and choose breathable, soft soil. Dip the leaves into a little rooting powder and insert them into the substrate to a depth of about 3-4 cm. After cutting, place it in a cool place, keep it well ventilated, spray water regularly to keep it moist, and keep it as warm as possible. It will take about half a month for roots to take root.

1. Cutting method

1. Cutting method

1. Cut leaves: Choosing leaves for cuttings is very critical. To cultivate a strong mother plant, the leaves cut from the top The survival rate is high. Select undamaged leaves and cut them off. They must be plump, fresh, and free of diseases and insect pests. Cut them into sections and place them aside to wait for the cuts to dry. Cuttings cannot be made directly. If the wound is not inserted into the soil dryly, it will cause rot.

2. Preparation of soil: Prepare the preparation For suitable soil, you can choose breathable and soft soil, or you can use vermiculite, perlite, river sand, etc. Do not use it after preparation, but must be disinfected first.

3. Make cuttings: Dip the dried leaves into a little rooting powder, and then insert them into the substrate to a depth of about 3-4 cm. Do not insert them too deep.

4. Later management: Place the cutting tiger orchid in a cool place, keep it well ventilated, spray water regularly to keep it moist, keep the surrounding temperature good, try to keep it warm, and wait for about half a month. Will take root, especially the rooting speed is slow, so you need to be patient and wait after cutting.

2. Cutting time

There are not many restrictions on the time for tiger orchid cuttings. Try to keep the time around March to September, and the temperature only needs to be kept above 15 degrees Celsius. Among them, cuttings are more advantageous in April to May in spring. .

2. Cutting time

- END -