How to take cuttings of money tree and how long does it take for the cuttings to take root?

Article Catalog

1. Cutting time

2. Cutting processing

3. Pot soil preparation

4. Carry out cuttings

---

Money tree cuttings are usually taken in spring and autumn. Due to the warmer climate, the plants are more likely to take root. Generally, leaves or leaf rachis are used as cuttings, and the rachis takes root and germinates faster. Before cutting, you need to prepare potting soil with peat soil, perlite and river sand, and mix the three in a ratio of 3:1:1. Insert the cuttings into it to a depth of about one-third, and then spray water appropriately. It usually takes 10-14 days to take root.

1. Cutting time

1. Cutting time

The time for cutting money tree is generally in spring and autumn. This is the growth period of the plant. The climate is warmer and it is easier to take root after cutting. If cuttings are taken in summer, because the temperature is too high, the bottom of the plant is prone to rot and the survival rate is relatively low. In winter, the temperature is too low and it is difficult for the cuttings to take root.

2. Cutting processing

There are two types of money tree cuttings, one is leaves and the other is leaf rachis. When using leaves as cuttings, make sure they are intact and have no wounds or diseased areas. Use the leaf rachis as a cutting, leaving at least two leaves on it. In comparison, the latter has faster rooting speed and a higher germination rate.

3. Pot soil preparation

< p>If leaves are used as cuttings, pot soil is generally prepared with a mixture of river sand and vermiculite, which can ensure a certain degree of air permeability and drainage. If you use leaf rachis as cuttings, you can use peat soil, perlite and river sand to prepare pot soil. The ratio of the three is 3:1:1. Since peat soil has a certain degree of water retention, it is also very suitable as a substrate for adult plants.

4. Make cuttings

Insert the leaves of the money tree into the substrate. Generally, small bulbous stems with roots will grow out in 10-14 days, and they will grow into small plants in 2-3 months. If you use leaf rachis cuttings, the depth should be about one-third or one-half. Spray water appropriately and place them in a semi-shady place. The temperature should be controlled between 25-27°C.

2. Cutting processing

3. Pot soil preparation

4. Carry out cuttings

- END -