How to propagate Antler Begonia

Article Catalog

how to reproduce

---

The propagation of Antler Begonia is mainly based on cuttings. Choose a substrate with good drainage and air permeability, and place an appropriate amount of plant material rich in corrosive nutrients underneath. After cutting, place it in a relatively cool place with astigmatism, and control the temperature at 20-35°C. If hyphae appear, spray fungicides promptly.

how to reproduce

How to propagate

Suitable cutting substrate

The propagation of Antler Begonia is mainly based on cuttings. The cutting substrate needs to have good performance, not only It needs to have good drainage function and breathability, as well as good function of retaining moisture and air. For example, perlite, peat ash, vermiculite, furnace ash, etc. can be used in conjunction with each other. But it must be disinfected before use. At the same time, an appropriate amount of plant material rich in corrosive nutrients needs to be laid below the matrix. It is best to use larger particles of plant material to lay the drainage layer at the bottom of the matrix.

Maintain air humidity

Be sure to avoid a sudden drop in the relative air humidity after cutting. It is best to keep it above 70%. Especially before rooting, it is recommended to keep the relative air humidity at 90%.

Appropriate lighting

After the antler begonia is cut, the light should not be too much or too little, otherwise it will affect the growth of adventitious roots and insufficient supply of nutrients. It is best to place it in a relatively cool place with astigmatism of light. Avoid direct sunlight and no complete darkness.

Suitable temperature

The most suitable temperature for cuttings of Staghorn Begonia is between 20 and 35 degrees, which can reduce the damage caused by rot bacteria during this period. Moreover, it is easier to take root when the temperature changes in the morning and evening than when the temperature is constant.

Conservation and Management

Antlers The details of protection after Begonia cuttings, to summarize what was said above, are to choose the appropriate temperature and substrate, maintain a high relative air humidity, and avoid direct sunlight. Once hyphae are found in the substrate, fungicides should be sprayed promptly. Everyone should remember not to move or touch them casually out of impatience.

- END -